22 Watt11.1 Volt 2000 mA/hour
Li-Polymer rechargeable Battery Pack~83x52x17mm,
~130 grams. Center +
~8 cm Cable. Charge 12.6~14.5 VDC ~1000 mA Max.
Back-Up
Camerapower
use with
Cable-2f1m for a quick
plug-in solution.
Inbuilt
Charger Module with individual Cell
management, over charge/discharge protection.
#1 38/41.5 x 72 x
26.5+24.3 mm, 108 grams. #2 27/40
x 68 x 40+26 mm, 105 grams.
Adaptors fit next to each other in
most General Purpose Outlets & Power Boards
#1
#2 Narrow-WidthSMPS Mains Adaptor / Plug Pack Click on
Dimensional Image to enlarge Regulated Switch Mode Mains Power Supply
Output: 12 Volts DC Regulated
1.5 Amp (1 500 mA maximum) Center (+)
~ 1500 mm Cable.
for
Network devices, Power over Ethernet Adapter, deliver data &
electrical power to Ethernet devices using a single Ethernet cable.
Eliminates the need to position LAN devices such as a
Network IP Camera,
Network Video Server, Wireless Access Point, etc., near a power
outlet, providing freedom of placement.
forBaluns &
unshielded twisted pair cable for transmission of Composite Video,
S-Video &/or Audio signals together with Power over single 4 pair
Cat-5 Cat-6 Cable. Eliminates the need to position CCTV Cameras near
a power outlet, providing freedom of placement.
Power over Ethernet (PoE)
Adapter is simple to
install, requiring no tools or software. Its compact size makes
installation easy. Connect the base unit (PoE Injector) to a power
outlet & connect the terminal unit (PoE Splitter) to your network
device using any standard Ethernet cable. Once set up, the PoE
Splitter can power any 5V or 9V or 12V Ethernet device.
Simplifies
installation of
Network devices &
CCTV Cameras allowing you to place them beyond the range of
standard power outlets and mount them in a ceiling or outside
without needing mains power nearby.
Power over Ethernet
(PoE) Adapter, allows power & data to be transmitted up to ~ 100
metres & power for CCTV
Camerasup to ~ 2 400 metres
(depending on load current) using standard Twisted Pair cabling .
More...
Injector Input: UNIVERSAL 100 ~ 240 volts ac,
50 ~ 60 Hertz via IEC-C14 socket
More...Injector Output:
48 VDC via TP Cable. Splitter Output: DC 5 V @ 1.5A or 9 V @
1.2A or 12 V @ 1A.
PoE
Adaptor for Network devices & Security Cameras
This easy Passive PoE (Power over Ethernet) Power Inserter/Extractor
utilises unused pairs (pins 4, 5, 7, 8) in a 100 baseT network cable
to transmit power to remote network devices. It is a low cost, easy
solution to provide power for network products that do not support
Power Over Ethernet or Security Cameras.
for
Network devices deliver data & electrical power to Ethernet
devices using a single Ethernet cable, eliminates the need to
position LAN devices such as
Network IP Cameras,
Network Video Server, Wireless Access Points, etc., near a power
outlet, providing freedom of placement.
forBaluns &
unshielded twisted pair cable for transmission of Composite Video,
S-Video &/or Audio signals together with Power over a single 4 pair
Cat-5 Cat-6 Cable, eliminates the need to position Security Cameras
near a power outlet, providing freedom of placement.Transmit
power 600 + metres via one pair using 24 vac Power &
Rectifier-Regulator.
Cable resistance, length & Load
Current affect cable voltage drop which can be reduced by using
thicker wire &/or paralleling pairs. A test using a 24 AWG
Cat-5 pair, 24 vac Power Supply,
REG-12VDC and a device that
draws 100 milliamps demonstrated that lengths of 600 + metres is
practical, 2 pairs in parallel would increase this to 1 200 +
metres.
A
single 24 AWG (0.5 mm diameter) conductor has a resistance of ~ 9.4
ohms per 100 metres, voltage drop will be ~ 1 volt per 50 metres of
Cat-5 Twisted Pair when powering a device that draws 100 milliamps.
(9.4 ohms x 0.1 amps = 0.94 Volts)
Power-Present Indicators, Surge protection &
Auto-Reset Fuses.
NINE Auto-Reset polymer-basedPositive
Temperature
Coefficient Fused outputs *
Surge protected input * NINE LED Output Status Indicators.
Power Cameras /
Microphones or other devices from a single Power Supply. Input
up to 30 volts AC or DC via Screw Terminals,
input Terminal labelled (+)
connects to output terminals labelled (+)
via PTC Fuses, Outputs are via 9 pairs of screw terminals, ~138 x 65
x 40 mm.
Mains Power Board 6 Way
6 Outlets, Neon Power Present indicator, ON/OFF
switch, Circuit breaker with Reset Button shuts off power in the
event of overloading.
Cat Code: REG12-Auto
Regulated 12 Volt Automotive Power Supply
Output: 12 Volts DC Regulated
1 Amp (1 000 mA maximum) 2.1 x 5.5 mm Plug Center (+).
Input Volts DC: 13.5
(nominal), 12.5 (min), 15 (peak) via 'Cigarette Lighter Plug' Center
(+),
LED Power-Present indicator. Filters common
Automobile Voltage Spikes / Sags / Surges. Taiwan Quality.
Single-Cable Solution Power-up-Cable 300 + metres
inbuilt ac/DC converter Powers Camera & compensates for cable
voltage drop. Pair this with any BalUn on this page.
Video via BNC Plug | Power via
Plug | Data via stripped & tinned
wires | Twisted Pair
via RJ45 8p8c socket | Power Input 18
~ 24 vac or 22 ~ 30 VDC via 2 parallel pairs | Output to
Camera 12 VDC Regulated 500 mA Max 2.1 x 5.5 mm Plug Center (+)
| Use with 24 vac Power Supply
& Auto-Reset fused Power
Distributor for multiple Cameras.
BalUn & Rectifier - Regulator
click on image to view typical
application
Output: 12 Volts DC Regulated250 milliamps when input is less than 20 volts 150
milliamps when greater 2.1 x 5.5 mm Plug Center (+).
Ideal for long power cable runs
where voltage drop due to cable resistance is a problem.
Input: 16 ~ 24 vac or 20 ~
30 VDC via 'Screw Terminal Block'. Use with
PP24/1A,
PS24/2A
In-Line Rectifier - Regulator
Output: 12 Volts DC Regulated.
Maximum 500 milliamps when input is less than 20 volts 450
milliamps when greater 2.1 x 5.5 mm Plug Center (+).
Ideal for long power cable runs where voltage drop due to cable
resistance is a problem.
Input: 18 ~ 24 vac or 22 ~ 30 VDC via 'Screw Terminal Block'.
Dimensions: ~ 28 x ~ 25 x ~ 45 mm, ~ 35 grams, ~ 150 mm Wires. Use
with PP24/1A,
PS24/2A.
In-Line Rectifier - Switch Mode Regulator
Output: 12 Volts DC Regulated.
Maximum 1000 milliamps when input is less than 20 volts
750 milliamps when greater 'Screw Terminals'.
Ideal for long power cable runs where voltage drop due to cable
resistance is a problem.
Input: 18 ~ 24 vac or 22 ~ 30 VDC via 'Screw Terminals'.
Dimensions: ~ 87 x ~ 25 x ~ 25 mm, ~ 80 grams. Use with
PP24/1A,
PS24/2A.
7.5 Amp (0.75 mm˛)
Power Cord 1800 mm Straight Plugpictured as used on
Personal Computers & other equipment in Australia & New Zealand,
suitable for use with REG12/5A,
DVMR,
UPS-DVR, etc.
7.5 Amp (0.75 mm˛)
Power Cord C-14 Plug to Australian/New Zealand 3 Pin Socket, ~ 150
mm used to convert C-13
UPS-DVR Output to common 3 Pin Mains Socket.
7.5 Amp (0.75 mm˛)
Power Cord ~ 1500 mm suitable for connecting
UPS-DVR output to REG12/5A,
DVMR, PC, etc.
7.5 Ampere Power Cord ~ 1800 mm as used on
Personal Computers & other equipment in Europe suitable for use with
DVMR, etc.
7.5 Ampere Power Cord ~ 1800 mm as used on
Personal Computers & other equipment in Europe suitable for use with
REG12/5A,
DVMR, etc.
7.5 Ampere Power Cord with Fuse ~ 1800 mm as used
on Personal Computers & other equipment in United Kingdom, Hong
Kong, Singapore, suitable for use with
REG12/5A,
DVMR, etc.
7.5 Ampere Power Cord ~ 1800 mm as used on
Personal Computers & other equipment in United States of America,
suitable for use with REG12/5A,
DVMR, etc.
USA Adaptor:
converts Australian pin pattern to United
States of America pin pattern
(2 parallel Rectangular & 1 Round pin)
suitable for use with REG12/1.5A &
REG12/1A .